Origin: Mainland China
Material: Other
Pieces Included: 1
With Magnetic: No
Model Number: Soldering Iron Cleaning Sponge
Name: Soldering Iron Cleaning Sponge
Apply to: Soldering Iron Cleaning Supplies
Features: High Temperature Resistant
Square Sponge: 6*6cm
Rectangle Sponge: 3.5*5cm
Round Sponge: 5.1cm
After soaking in water Thickness: 6mm
Soldering Iron Cleaning Sponge Reusable Yellow High Temperature Resistant Sponge Pad Tin Removal Sheet For Cleaning Supplies
The role of soldering iron cleaning cotton:
The tip of the soldering iron must be heated before each soldering, and the soldering interval must be air-heated, so that an oxide layer will appear on the surface of the solder remaining on the tip of the soldering iron. In addition, the residual flux (such as rosin or petroleum jelly, etc.) will also become carbon deposits and dirt attached to the surface of the soldering iron tip. If they are not removed, they will be welded, which will reduce the mechanical strength, electrical contact performance and smoothness of the welding, which will directly affect the quality of the welding. In order to ensure the quality of soldering, it is necessary to use a cleaning block to wipe off these dirt, and then to melt the solder.
How ??to use:
First let the cleaning block absorb enough water, squeeze some by hand, and retain about 70% of the water. Take the soldering iron handle and rub the heated soldering iron tip on the cleaning block twice, the tin layer on it will be as bright as new, and the soldering iron tip will be clean. You can start soldering immediately.
The high-quality soldering sponge is placed on the soldering iron stand to clean the soldering tip of the soldering iron. It can quickly clean the oxide on the surface of the soldering iron tip without damaging the alloy layer of the soldering iron tip. Prevent the soldering iron tip from oxidizing, overheating and burning, removing solder residues, and keeping PCB components clean.The soldering iron stand must be used with cleaning sponges.When using, put the sponge in the water, it will swell in contact with water. The sponge must be soaked in water, not too much but not too little, and squeeze out the excess water, so that a good cleaning effect of the welding tip can be obtained. If the cleaning sponge is not used, the solder tip will be damaged and the tin will not be applied.