Notice:
It should take more patient to install the glass protector:
Step 1 : Clean the screen with the wet wipe and cloth and removing any case from you phone
Step 2 : Stick the key hole with a label,and then use a knife or scissor open the liquid adhesive box,drop it on the screen(It is recommended that the glue be poured completely.The glue that drops on the screen can&39;t have air bubbles, if there is air bubble, use the needle to pierce the air bubble to let go air. )
Step 3 : Peel off the mask film from the glass,then place the screen protector to a suitable position on your device SLOWLY. PLEASE DO NOT LIFT AND PRESS THE GLASS TO LET THE ADHESIVE SPREAD,JUST LET IT AUTOMATIC DISPERSION.(Very important)
Step 4 : Wait for about half a minute to let the adhesive spread and level.
Step 5 : If the adhesive overflow, wipe off with a clean cloth. After checking the retention criteria for the mobile phone&39;s tempered film, the lamp was turned back and forth several times around the edge of the phone, and after 3 seconds of initial curing (not in the middle), the edge glue was wiped again until the glue overflowed. (Prevent white edges or long bubbles on edges)
Step 6 : Wait for the exhaust to complete, after the glue overflows cleanly, after the positioning standard of the tempered film is satisfied, turn on the light. Otherwise scrapped material.
Step 7 : Irradiate the mobile phone under UV lamp and need to illuminate twice for about 3 minutes to reach the fully-cured position.
Step 8 : Clear the screen,and turn off the UV lamp for reuse.
Be careful not to let the UV glue flow into the speaker hole.
1PC include:1*UV lamp + 1*tempered glass+ 1*glue
2PC include: 1*UV lamp + 2*tempered glass+ 2*glue