3S 10A 11.1V lipo lithium Polymer BMS/PCM/PCB battery protection board for 3 Packs 18650 Li-ion Battery Cell
3S 10A 12.6v li-ion BMS PCM battery protection board bms for lithium LicoO2 Limn2O4 18650 li battery
It is without balancing function, you can buy our 3S li-ion balancing board if you need balancing function for 3s battery packs.
this board not suit electric tools, if your application is high current application, like screwdriver and drill, please do not buy, should select our other high current BMS.
Features:
1) high-accuracy voltage detection circuit;
2) terminal of the charger using high voltage device;
3) Built-in three-stage over-current detection circuit (over-current 1, over-current 2, or load short circuit);
4) MOS transistor can control the battery charge and discharge;
5) low standby current consumption.
Notice:
1. Please pay attention to the use condition of input and output voltage and load current , make the protective plate within the power consumption of no more than specification allows power consumption;
2. Connect the battery will happen cannot discharge status, in this case, connect the charge can be restored to normal working state;
3.If a set of batteries with over-discharge and over-charge cells, the bms cannot be charge and discharge.
Aplicaciones:
3S li-ion18650, licoo2, limn2o4, Li (nicomn) O2 baterías recargables
3S lipo baterías recargables
over discharge: 4.3V
over charge: 2.3V
continous current: 10A
over current: 20A
size: 51mm*23mm*4mm
BMS solder instruction:
P+: charge/ discharge positive
P-: charge/discharge negative
note: if P+ to P- is 0V, no output, please use 12.6V charger(power supply) to charge the BMS, active it, then discharge can work.
battery need match, battery should have good consistency, if not sure, please use new brand battery.
3S/10A without balance function, if you want balance function. you can buy our 3S balance board.
(3S balance board) + (3S/10A without balance) = (3S/10A with balance function)
SMT Workshop:
you may like: