Specification:
Input Power: DC10V-14V
RF Frequency: 433Mhz
RF working mode: superheterodyne
Receive sensitivity: >97dbm
Decoding mode: MCU software decoding
Remote storage: 25pcs
Support remote type: Learning code, Fixed code (it can learn 2272 2262 or 1527 chip with the different code wireless 433MHz remote control )
Working mode: Momentary(Jog/Non-Latched), Toggle(Self -lock/Self-Latched),Latching (Inter-lock /Latched) ,Time delay (5s ,10s ,15s )
Wiring type: fixed terminal
Output Terminal : NO , NC , COM
Dimension of PCB:35*30*18mm (L,W,H)
Wiring diagram 1:
+V : 12V + input ;
- V: 12V - input ;
NO: Output , normal open;
COM:Output , common ;
NC: Output , normal close;
4 Working mode:
1) Momentary(Jog/Non-Latched) : Press one button is Working /ON. Loosen your finger on the same button is Stop/OFF. One channel switch need one buttons remote control.
2) Toggle(Self -lock/Self-Latched) : Press one button for one time is working/ON. Press the same button again is stop/OFF. 1 channel switch need one buttons remote control.
3) Latching (Inter-lock /Latched) : Press one button is working/ON, press another button is stop/OFF. 1 channel switch need 2 buttons remote control.
4)Time delay (5s ,10s ,15s ) : Press the remote control button , the relay connects , from when release the remote button , after 5s or 10s or 15s , the relay disconnect automatically.
Clearing the code :
Push the learning button on the receivers for 8 times , the codes will be cleaned .
After clearing the code, all the remote control cannot work any more.
Learning the code : Momentary (Jog/Non-Latched)
Push the learning key on the receiver once time , it comes into momentary setting mode .
Wait for a moment , the LED will be off , it comes into learning state .
Push the remote button , LED indicator on the receiver board will flash then come off .
After 3 seconds, the LED indicator will be on again , learning successfully .
Learning the code : Toggle (Self -lock/Self-Latched)
Push the learning key on the receiver twice time , it comes into toggle setting mode
Wait for a moment , the LED will be off , it comes into learning state .
Push the remote button,LED indicator on the receiver board will flash then come off.
After 3 seconds , the LED indicator will be on again , learning successfully .
Learning the code : Latching (Inter-lock /Latched)
Note: When you choose for latching mode , in order to learn more remote control , you need to learn two different button , the first time learnt is for “ON”, the second time learnt for “OFF”. 1 channel switch need 2 buttons remote control.
For example : button A = ON , button B = OFF
Push the learning key on the receiver triple time , it comes into latching mode .
Wait for a moment , the LED indicator on the receiver board will flash then come off.
Push the remote button A .
LED flash for 5 times .
Push the remote button B .
Led flash for 5 times .
After 3 seconds , the LED indicator will be on again , learning successfully.
A = ON , B = OFF .
Learning the code :( Time delay mode )
Push the learning key on the receiver fourth time , the time delay for 5 seconds .
Push the learning key on the receiver fifth time , the time delay for 10 seconds .
Push the learning key on the receiver sixth time , the time delay for 15 seconds .
The LED indicator will be off .
Push the remote button , LED flashes and off .
After 3 seconds , the LED indicator will be on again , learning successfully .
NOTE: The system can store for 25 pcs of remotes , if the remote get more than 25 pcs , the initial remote control will be lost .