NEW Upgraded Edition OF TA7318P VU Meter Driver PCB Board Stereo Module
Instructions:
This is a upgraded edition of TA7318P driver board, this upgraded edition is better at the driver effect,
pointer is swinging rapidly,increase driver signal based on previous TA7318P driver board,
can drive some VU meter which the previous TA7318P board can't drive,
This upgraded edition has increased wide voltage circuit, work more stable performance.
You can view the previous edition of TA7318P driver board in below link:
Instructions for use:
1. Signal input: The driver board provides two kinds of signal input methods, which can be arbitrarily selected according to your situation (Hint: If the signal is taken at the back end of the volume potentiometer or the output of the power amplifier, the pointer swing will be controlled by the volume potentiometer, that is, the volume of the large pointer swings large, and the volume is small, the pointer swing is small.)
1 LOW, GND, LOW: This is the low-level signal input terminal of the driver board. It is used to connect the audio signals of the CD player, computer sound card, preamp, and other audio source devices. When wiring, LOW, GND, and LOW correspond respectively: Left, The ground and right channel can be used.
(Adjust the two potentiometers on the driver board to control the size of the meter swing. If the signal is full, the pointer swing fails to meet your expected value, or the volume becomes small, you can press R2 on the driver board. The R3 resistor is removed. R2 and R3 are the grounding attenuation resistors used when the driver board is connected to the high-level input signal. It is only used when the high-level input is used, because there is no way to determine which signal input you use. The way, so the resistance is good when welding, it is much easier to remove the resistor than to solder. After all, not everyone has welding equipment, huh, huh, of course, this is a very special situation, usually do not need to be removed)
2HIGH, GND, HIGH: This is the high-level signal input terminal of the driver board. It is used to connect the amplified power signal through the power amplifier. The attenuation circuit in the driver board will attenuate the high-intensity level of the amplifier output. The driver IC, the attenuation circuit contains the resistors R2 and R3 just mentioned. When connecting the output terminals of the power amplifier, the two HIGH terminals of the driver board are respectively connected to the two red terminals of the power amplifier, and the two black terminals of the power amplifier. Select one of the GND terminals of the driver board.
2. Drive output:
V+, V-, terminal: This is the two sets of 12V backlight power supply output terminals provided by the driver board for the backlight of the meter. Please pay attention to the voltage and positive and negative direction of the head light source when connecting.
+, -, terminal: This is the output terminal of the drive board drive meter, which is connected to the + and - terminals of the two level meters. Pay attention to the positive and negative directions when connecting.
3. Power supply parameters:
Operating voltage: AC / DC 12-15V AC and DC wide range of operating voltage (recommended to use a separate power transformer, or independent winding power supply)
Rated power: 3W
4. PCB size: 60*39mm