Product information:
Low-power dual-core 32-bit CPU, can be used as application processor,
Main frequency up to 240MHz, computing power up to 600 DMIPS,
Built-in 520 KB SRAM, external 4M PSRAM.
Supports UART / SPI / I2C / PWM / ADC / DAC and other interfaces,
Supports OV2640 and OV7670 cameras, built-in flash,
Support picture WiFi upload,
Support TF card,
Supports multiple sleep modes,
Built-in Lwip and FreeRTOS,
Support STA / AP / STA + AP working mode,
Support Smart Config / AirKiss,
Support secondary development.
Notice:
1. Please ensure that the input power of the module is at least 5V 2A,
otherwise there will be a chance of water ripples in the picture.
2.ESP32 GPIO32 pin controls camera power.
When the camera is working, please pull GPIO32 low.
3. Because IO0 is connected to the camera XCLK,
please leave IO0 unconnected when using, do not connect high or low level.
4. The default firmware is included in the factory. It is not provided for download.
If you need to re-burn other firmware, please proceed with caution.
Application areas:
Home smart device image transmission,
Wireless monitoring,
Smart agriculture,
QR wireless identification.
Package includes: 1pc ESP32-CAM OV2640 Camera Module Board
Note:
1. please check the size carefully when you place the order, please allow 0-1cm differences due to manual measurement.
2. Item color displayed in photos may be showing slightly different on your computer monitorsince monitors are not calibrated same.
3. The product will be upgraded constantly, the appearance and color may be changed, please don&x27;t mind. And take a consideration before place the order if you have request for color or appearance.